Product Reference Guide
183
BC412 Set Length 1
This feature specifies one of the bar code lengths for Code 11 Length Con-
trol. Length 1 is the minimum label length if in Variable Length Mode, or the
first fixed length if in Fixed Length Mode. Length includes the bar code’s
check and data characters. The length can be set from 2 to 50 characters.
Table 16 provides some examples for setting Length 1. See page 266 for
detailed instructions on setting this feature.
Table 24. BC412 Length 1 Setting Examples
STEP ACTION EXAMPLES
1
Desired Setting (pad with
le
ading zeroes)
02 Characters 07 Characters 15 Characters 50 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 11 LENGTH 1 SETTING
4
Scan Two Characters From
Appendix D, Keypad
‘0’ and ‘2’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select BC412 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, t
hen the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
th
e ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not
save the entry string. You can then start again at the
beginning.
CANCEL
04 = Length 1 is 4 Characters
To Next Page
Loading...
Need help?
General
