Datalogic PD9330 - Datalogic 2 of 5 Set Length 2

Enter/Exit Programming Mode
128 PowerScan™ PD9330/PBT9300/PM9300
Datalogic 2 of 5 Set Length 2
This setting has no effect for AR models.
This feature specifies one of the bar code lengths for Datalogic 2 of 5
Length Control. Length 2 is the maximum label length if in Variable Length
Mode, or the second fixed length if in Fixed Length Mode. The length
includes the bar code’s da
ta characters only.
The length can be set from 2 to 50 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See
"Set Length 2" on page 241 for more detailed programming
instructions.
$CD2L2
Select Datalogic 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
code
above, then the bar code at left followed by dig-
its from the Alphanumeric c
haracters in Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and
not save the entry string. You can then start
again at the beginning.
~
CANCEL
50 = Length 2 is 50 Characters
DEFAULT