Datalogic PD9330 - ABC Codabar Dynamic Concatenation Timeout; ABC Codabar Force Concatenation

Enter/Exit Programming Mode
152 PowerScan™ PD9330/PBT9300/PM9300
ABC Codabar Dynamic Concatenation Timeout
This parameter specifies the timeout in 10-millisecond ticks used by the ABC Codabar
Dynamic Concatenation Mode. The timeout can be set within a range of 05 to 255 in 10ms
increments. A setting of zero specifies no delay.
$CKBQI
Select ABC Codabar Dynamic Concatenation
Timeout Setting
To configure this feature, scan the ENTER/EXIT
bar code above, then the bar code at left fol-
lowed by digits from the Alphanumeric charac-
ters in Appendix D, Keypad representing your
desired character(s). End by scanning the
E
NTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the
entry string. You can then start
again at the beginning.
~
CANCEL
10 = Quiet Interval of 200 ms
DEFAULT
ABC Codabar Force Concatenation
Forces labels starting or ending with D to be concatenated.
DEFAULT
$CCBFC00
ABC Codabar Force Concatenation = Disable
$CCBFC01
ABC Codabar Force Concatenation = Enable