Datalogic PD9330 - Configure Actions for F4 (16-Key Models Only); Configure Actions for Shift (16-Key Models Only)

$CPWES0000\r
F4 No Actions Configured
$CPWES
Configure Actions for F4
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Func
tion Key you want to program. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0, the second digit must be con-
figured according to the CMD_ID numbers in Table 27 on
page 253. The third and fourth must be
zero. Confirm
the inserted value by scanning the ENTER/EXIT bar code
Enter/Exit Programming Mode
Product Reference Guide 237
Configure Actions for F4 (16-key models only)
$CPWEQ0000\r
Shift No Actions Configured
$CPWEQ
Configure Actions for Shift
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, disable the SHIFT by
reading "Disable SHIFT function" on page 266, then re
ad
"Configure Actions for Shift" on the left. Next scan 4 dig-
its from the Alphanumeric characters in Appendix D,
Key
pad. The first digit must be 0, the second digit must
be configured according to the CMD_ID numbers in Table
27 on page 253 . The third and fourth digit must be zero.
Configure Actions for Shift (16-key models only)