Datalogic PD9330 User Manual

Enter/Exit Programming Mode
Product Reference Guide 239
Set String ID
Sets the identifier of the predefined strings.
$CPWEB
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left fol
lowed by 6 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad .
The ID characters must be represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this feature
is disabled. E
nd by scanning the ENTER/EXIT bar code
twice.
Make a mistake? Scan the CANCEL bar code to abort and
not
save the entry string. You can then start again at the
beginning.
~
CANCEL
Set String Header
Sets the header of the predefined strings.
$CPWED
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left fol
lowed by 32 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representation
of the desired characters. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar c
ode twice.
Make a mistake? Scan the CANCEL bar code to abort and
not
save the entry string. You can then start again at the
beginning.
~
CANCEL

Datalogic PD9330 Specifications

General

Brand	Datalogic
Model	PD9330
Category	Barcode Reader
Language	English