Enter/Exit Programming Mode
236
PowerScan™ PD9330/PBT9300/PM9300
FUNCTION KEYS CONFIGURATION (16-KEY MODELS ONLY)
Function Keys F3 through F5 are available on 16-key models only. For more
16-key programming, see "Additional Features for 16-key models" on
page 241.
F3 No Actions Configured
Configure Actions for F3
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to pro
gram. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0, the second digit must be con-
figured according to the CMD_ID numbers in Table 27 on
page
253 . The third and fourth must be zero. Confirm
the inserted value by scanning the ENTER/EXIT bar
code.
Configure Actions for F3 (16-key models only)
Configure Actions for F2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to pro
gram. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0, the
second is used by 4K and
16K model, the remaining third and fourth are used only
by 4K model. Second, third and fourth digit must be con-
figured according to the CMD_ID numbers in Table 27 on
page
253. Confirm the inserted value by scanning the
ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort and
not save the ent
ry string. You can then start again at the
beginning.
CANCEL
To Next Page
Loading...
Need help?
General
