Enter/Exit Programming Mode
Product Reference Guide
207
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
Set Source Radio Address Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left fol
lowed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTE
R/EXIT
bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and not save the
entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
00 = No Delimiter Character
This feature only applies if
"Source Radio Address Transmis-
sion"
on page 206 is enabled.
To Next Page
Loading...
Need help?
General
