Datalogic PD9330 - Stop Bits; Parity

Enter/Exit Programming Mode
Product Reference Guide 27
Stop Bits
Set the number of stop bits to match host device requirements. See
page 254 for more information on
this feature.
DEFAULT
$CR2ST00(CR)
1 Stop Bit
$CR2ST01(CR)
2 Stop Bits
Parity
This feature specifies parity required for sending and receiving data. Select
the parity type according to host device requirements. See page 254 for
more information.
DEFAULT
$CR2PA00(CR)
Parity = None
$CR2PA01(CR)
Parity = Even
$CR2PA02(CR)
Parity = Odd