To Next Page

To Previous Page

Enter/Exit Programming Mode

PowerScan™ PD9330/PBT9300/PM9300

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON

state once the state is entered. The range for this setting is from 1 to 255

seconds in 1-second increments. See page 277 in “References” for further

description of this feature.

$CSNET03(CR)

Scanning Active Time = 3 seconds

$CSNET05(CR)

Scanning Active Time = 5 seconds

DEFAULT

$CSNET08(CR)

Scanning Active Time = 8 seconds

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.

The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in

100 millisecond increments. See page 278 in “References” for detailed infor-

mation on setting this feature.

$CSNFN

Select Flash ON Time Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the

ENTER/EXIT bar code twice.

Make a mistake? Scan the CANCEL

bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

10 = Flash is ON for 1 Second

Datalogic PD9330 User Manual

Other manuals for Datalogic PD9330