To Next Page

To Previous Page

Enter/Exit Programming Mode

PowerScan™ PD9330/PBT9300/PM9300

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains

on following a good read. The good read LED on time can be set within a

range of 100 milliseconds to 25,500 milliseconds (0.1 to 25.5 seconds) in

100ms increments. A setting of 00 keeps the LED on until the next trigger

pull.

See page 276 in “References” for detailed instructions and examples for set-

ting this feature.

$CLAGL00(CR)

Good Read LED Duration Setting =

Keep LED on until next trigger pull

$CLAGL

Select Good Read LED Duration Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the

ENTER/EXIT bar code twice.

Make a mistake? Scan the CANCEL

bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

003 = Good Read LED

stays on for 300 ms.

Indicators are dimmed during sleep.

Datalogic PD9330 User Manual

Other manuals for Datalogic PD9330