Enter/Exit Programming Mode
Product Reference Guide
223
PM9300-ONLY FEATURES
The features in this section are valid only for the PowerScan PM9300 Star
model:
• STAR Radio Protocol Timeout on page 223
• STAR Radio Transmit Mode on page 224
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is
from
02 to 25 seconds. See page 280 in “References” for detailed informa-
tion and examples for setting this feature.
Set Radio Protocol Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by two di
gits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the
ENTER/EXIT bar code twi
ce.
Make a mistake? Scan the CANCEL barcode to abort
and not save the
entry string. You can then start again
at the beginning.
CANCEL
02 = 2 Seconds Radio Protocol Timeout
To Next Page
Loading...
Need help?
General
