Selecting a function
1. Highlight a category or group, by pressing Up or Down .
2. Select the highlighted category or group, by pressing OK .
• Another group may be shown or the function list to select the actual function.
• If another group is shown, repeat step 1 to locate and open the required group.
3. Highlight the required function, by pressing Up or Down .
4. Enable the highlighted function, by pressing OK
.
• Selected function are shown with a solid box.
•
5. To clear all the Enabled function, select Clear
.
6. To save the settings to the controller, select Write
.
PPM 300 Operator's manual 4189340910 UK
To Next Page
Loading...
