INFO
This is the y-axis.
2. Highlight the required output type, by pressing Up or Down .
3. Select the highlighted output type, by pressing OK
.
• The selected output type is marked with a solid box.
•
4. To proceed to the next stage, select Next
.
•
You can now choose to do one of the following:
• Select a pre-configured curve (if available).
• Select a new custom curve.
• Select or edit an existing custom curve.
PPM 300 Operator's manual 4189340910 UK
www.deif.com Page 105 of 157
To Next Page
Loading...
