Deif PPM 300 - Page 20

Operator info Additional information
GB is open The Generator breaker is open. ● ●
GB is synchronising The Generator breaker is synchronising. ● ●
GB open and stop not
possible in SWBD
While the controller is under switchboard
controller, operator actions cannot be
performed from the controller interfaces.
●
GB open cancelled
Opening the Generator breaker has been
cancelled.
● ●
GB open not possible
in SWBD
While the controller is under switchboard
controller, operator actions cannot be
performed from the controller interfaces.
● ●
Harbour operation
activated
Harbour operation has been activated. ●
Harbour operation
deactivated
Harbour operation has been deactivated. ●
Load-dependent stop
block activated
The Block load-dependent stop function is
active.
● ● ● ● ●
Load-dependent stop
block deactivated
The Block load-dependent stop function is
not active.
● ● ● ● ●
Load on busbar too
high
A shaft generator in power take home
mode cannot be connected to the busbar
because the additional load will cause a
blackout (overload on the busbar).
●
Load on SC too high
(Ship-to-ship)
The shore connection breaker will not
open because the load consumed by the
receiving ship is too high.
●
Load on SG too high
(PTH)
The shaft generator breaker will not open
because the load to drive the propeller is
too high.
●
Mode change locked
It is not possible to change to SEMI or
AUTO mode while the controller is under
switchboard control.
● ●
No genset ready to
start
There is no genset is in AUTO and Ready
for operation to take over the load after
opening the [Breaker].
● ●
Not in SEMI mode
The action cannot be performed unless
the controller is in SEMI mode.
● ●
Only one genset
connected
There is only one genset connected to the
busbar. Opening the generator breaker
will cause a blackout.
●
Pitch not zero
The shaft generator breaker cannot open
because the Zero pitch parameter is set
but not activated. Activate Zero pitch
before attempting to open the breaker.
●
Possible to remove
latches
There are acknowledged latched alarms in
the alarm list that can be reset.
● ● ● ● ●
PTH mode activated
The Power take home parameter is
activated.
●
PPM 300 Operator's manual 4189340910 UK
www.deif.com
Page 20 of 157