•
a. Highlight the required alarm setting, by pressing Up or Down .
b. To change the setting, press OK .
◦ If the setting is Enable or Not enabled, pressing OK toggles either Enable or Not enabled.
◦ Enabled settings are marked with a solid box.
◦ If the setting is text or a value, pressing OK displays the virtual keyboard to alter the setting.
◦ Make the required changes using the virtual keyboard.
◦ To confirm the changes, select Next
.
◦ If the setting is a selection, pressing OK displays an available list of selection options.
◦ Highlight the option required, by pressing Up
or Down .
◦ Select or unselect the option, by pressing OK .
◦ To confirm the setting, select Next
.
c. Once you have made all the required changes to the alarm settings, select Write
.
◦ This saves the alarm setting to the controller. This does not save any other settings.
◦ The list of available alarms is shown again on the display.
3. To save the new setting to the controller, select Write
.
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
Clear all enabled alarm(s)
1. To clear all the selected alarms, select Clear
.
2. To save the new setting to the controller, select Write
.
• This only saves the selected alarm(s) and their settings to the controller. It does not save other I/O settings.
PPM 300 Operator's manual 4189340910 UK
To Next Page
Loading...
