116
Page Destination Configuration
The Page Destination Configuration screen, shown in Figure 41, is displayed when you click
Next on the Destination Dial Strings screen. This screen allows you to configure the settings for
each page destination that can be reached by sending a page through the serial/modem channel. Up
to eight page destinations can be configured; the Dial String column displays Not Configured for
any entry that has not been configured.
A page destination is comprised of:
• A dial string to be used when a page is to be sent out
• Retry information for the page
• Configuration of the modem at the destination
The data shown for each page destination includes the dial string, call retries, flow control, baud
rate, parity, data bits, and stop bits for the destination modem. These settings are described in more
detail in the next section. This screen also displays general settings that apply to all alerts to be sent
as dial pages.
Figure 41. Page Destination Configuration
To Next Page
Loading...
