161
Shutting Down the Server
To shut down the server you must exit the operating system (if applicable) and then use the power
button to power down the server.
Follow these steps to power down the server.
1. If the server is running an operating system, use the operating system commands or GUI to
logoff if necessary and exit the operating system. Successfully exiting the operating system
causes the following prompt to appear:
Shell>
2. When this prompt appears, press and hold the power button for several seconds to power down
the server.
CAUTION
Powering down the server with the power button does not remove all power from the system. The
+12 V standby power is still available to the system even when it has been powered down. To
remove standby power from the system you must unplug both power cords from the chassis.
To Next Page
Loading...
