77
LSI Logic* SCSI Utility
The LSI Logic* SCSI utility allows you to configure the SCSI capabilities of the server. This
configuration utility can be accessed using an EFI-based utility provided by Intel. Contact your
Intel representative for information on obtaining this utility.
Use the command EFICnfg.efi to start the EFI utility from the EFI shell prompt. The utility
contains help information at the bottom of each screen.
NOTE
This utility is still being defined and changes may occur in the menus shown
below. Entrance into this utility may be updated in a future revision of this
document.
To run the LSI SCSI utility:
1. From the EFI Shell, run EFICnfg.efi to enter the LSI Logic SCSI Utility. The following
information is displayed:
Intel’s EFI Configuration program ver 0.5
Serial # Controller description
1. OnBoard Function0 USB Universal Host Controller
2. OnBoard Function1 USB Universal Host Controller
3. OnBoard Function0 LSI Logic Ultra320 SCSI Controller
4. OnBoard Function1 LSI Logic Ultra320 SCSI Controller
Please enter a serial number (Enter 0 to Exit):
To Next Page
Loading...
