75
Security
Table 12 describes the menu items available on the Security screen.
NOTE
With the removal of legacy keyboard and mouse support, the legacy security
core has been removed. Therefore, the security menu is brief as compared to
other server products. The two-level password has been replaced with a
single-level password.
Table 12. BIOS Setup Security Screen Menu Items
Menu Item Default Value Description
Password Is Clear
Set
Status only. Once set, can be disabled by setting to a null
string, or clear password jumper on board.
Set Password Press <Enter> When the <Enter> key is pressed, you are prompted for a
password, press ESC key to abort. Once set, can be
disabled by setting to a null string, or clear password jumper
on board.
System Management
Table 13 describes the menu items available on the System Management screen. Default values
appear in brackets.
Table 13. BIOS Setup System Management Screen Menu Items
Menu Item Default Value Description
Quiet Boot [Enabled]
Disabled
Selecting this option enables the BIOS to display the OEM
logo during POST. If disabled, the BIOS displays the normal
POST messages.
This option is hidden if the BIOS does not detect a valid logo
in the flash area reserved for this purpose.
Enabling this option disables serial redirection.
Service Partition [Disabled]
Enabled
Enabling this item allows you to boot into Service Partition
Boot mode. The item automatically resets to Disabled on the
next system boot.
Console Redirection Press <Enter>
to present
selection
submenu
Selecting this option allows you to configure for console
redirection.
Serial Over LAN (SOL) [Disabled]
Enabled
Use this to enable SOL feature. Note that the serial settings
need to be set in the Console Redirection menu.
OS Load WDT [Enabled]
Disabled
Enabled the OS load watchdog timer.
BMC Revision [BMC_Rev] The currently loaded version of Baseboard Management
Controller firmware. You cannot change this value. It
appears for informational purposes only.
To Next Page
Loading...
