190
Figure 69. Removing the Peripheral Bay
Installing the Peripheral Bay
1. Install the peripheral bay in the chassis by locating the four alignment studs (two each side) in
the corresponding chassis cutouts and lower the assembly into position.
2. Push the assembly rearward and fasten the retaining screw.
3. Reconnect all cables that were removed:
Connect flex cable from the main board to J1A1 on the peripheral board
The main DC power harness from the power bay to J9B1 on the SCSI board.
The DC Y-cable from the SCSI board at J5B1 to J2B1 on the peripheral board and then to
the CD/DVD device power connector.
The SCSI backplane cable from the main board to position J4B1 on the SCSI backplane
board.
The peripheral interface ribbon cable form J1C1 on the SCSI board to J1D1 on the
peripheral board.
The IDE ribbon cable at position J4D1on the peripheral board to the DVD/CD-ROM IDE
interface.
To Next Page
Loading...
