94
Alert Settings
Up to four LAN alert destinations can be configured. When one or more IP addresses are
configured as alert destinations, this part of the screen shows those addresses, along with the
following associated configuration settings:
• Gateway IP address for the destination IP address.
• Whether alert acknowledge is enabled for the alerts sent to this destination.
• The number of times the alert will be retried.
• The interval in milliseconds between retries.
New, Edit, and Delete Buttons
If no alerts are configured, only the New button is enabled.
• New: When the New button is clicked, you are shown a screen on which you can configure a
new LAN destination address. See the following section for details.
• Edit: If you select an IP address and then click the Edit button, you are shown a screen where
you can edit the configuration for the selected IP address. See the following section for details.
• Delete: If you select an IP address and then click the Delete button, the selected IP address is
deleted. Before deleting the IP address, you are prompted by a confirmation prompt. If you
click OK to confirm deleting the address, the LAN Alerting Configuration screen is
redisplayed with the deleted address no longer shown.
These buttons affect only the copy of the firmware data internal to the SMU; changes are written to
nonvolatile storage in the firmware only after you select the Save button in the last LAN
configuration screen.
To Next Page
Loading...
