AirWave Wireless Management Suite | Configuration Guide Aruba Configuration Reference | 125
AP Load Balancing
Max Retries
(0-100,000)
8 Set the maximum number of times that an AP attempts load balancing
before timing out.
AP Load Balancing
User High
Watermark
(0-100,000)
0 Set the high watermark level for the number of users that AP load balancing
is to support. The supported range is 0 to 100,000 users, and setting this
field to 0 users disables this function. When the number of users exceeds
the high watermark, it triggers an alert.
AP Load Balancing
User Low
Watermark
(0-100,000)
0 Set the low watermark level for the number of users that AP load balancing
is to support. The supported range is 0 to 100,000 users, and setting this
field to 0 users disables this function. When the number of users exceeds
the low watermark, it triggers an alert.
AP Load Balancing
Util High
Watermark
(0-100%)
0 Set the high watermark level as a percentage of load balancing utilization.
The supported range is 0 to 100%, and a value of 0% disables this function.
When this watermark is exceeded, it triggers an alert or wait time.
AP Load Balancing
Util Low
Watermark
(0-100%)
0 Set the low watermark level as a percentage of load balancing utilization.
The supported range is 0 to 100%, and a value of 0% disables this function.
When this watermark is exceeded, it triggers an alert or wait time.
AP Load Balancing
Util Wait Time
(0-360,000 sec)
0 Set the wait time for the AP when AP load balancing is enabled. When load
balancing thresholds are exceeded, this setting defines the length of time
before AP load balancing restarts on the AP. The supported range is 0 to
360,000 seconds, and defining a value of 0 disables this function.
Station Handoff
Assist
No Enable or disable the ability of APs to hand users over to another adjacent
AP, as available, in order to optimize or improve general network load.
Detect Association
Failure
No Enable or disable an AP’s ability to detect failures in wireless user
associations.
Coverage Hole
Detection
No Enable or disable an AP’s ability to detect areas where an otherwise good
RF signal is not reaching wireless clients to an adequate level.
This setting requires a Wireless Intrusion Protection license.
Hole Good RSSI
Threshold
(0-65,535)
20 Set the amount of time in seconds during which Received Signal Strength
Indication (RSSI) is to check coverage holes.
This setting requires a Wireless Intrusion Protection license.
Hole Good Station
Ageout (sec)
30 Set the amount of time in seconds that an AP is unseen by any probes
before it is deleted from the database. Enter 0 to disable ageout.
This setting requires a Wireless Intrusion Protection license.
Hole Detection
Interval (sec)
180 Sets the amount of time in seconds in which automatic hole detection
should check for coverage holes. Enter 0 to disable this function.
This setting requires a Wireless Intrusion Protection license.
Hole Idle Station
Timeout (sec)
90 Sets the amount of time in seconds before which an idle AP is deleted from
the database, once it has become idle. Enter 0 to disable this function.
This setting requires a Wireless Intrusion Protection license.
Hole Poor RSSI
Threshold
(0-65,535)
10 Sets the threshold at which RSSI deems coverage to be poor.
Detect
Interference
No Enables or disables interference detection for the APs to be configured with
this optimization profile.
Table 47 Aruba Configuration > Profiles > RF > Optimization Profile Settings (Continued)
Field Default Description
To Next Page
Loading...
