AirWave Wireless Management Suite | Configuration Guide Using Aruba Configuration in Daily Operations | 33
Chapter 2
Using Aruba Configuration in
Daily Operations
Introduction
This chapter presents the more common tasks or concepts after initial setup of Aruba Configuration is
complete, as described in the section “Setting Up Initial Aruba Configuration” on page24. This chapter
emphasizes frequent procedures as follows:
General Aruba AP Groups Procedures and Guidelines
z Guidelines and Pages for Aruba AP Groups in Aruba Configuration
z Selecting Aruba Controller Groups
z Configuring Aruba AP Groups
General WLAN Procedures and Guidelines
z Guidelines and Pages for WLANs in Aruba Configuration
z Configuring or Editing WLANs with Basic View
z Configuring or Editing WLANs with Advanced View
General Controller Procedures and Guidelines
z Using Master, Standby Master, and Local Controllers in Aruba Configuration
z Pushing Device Configurations to Controllers
Supporting APs with Aruba Configuration
z AP Overrides Guidelines
z Configuring or Editing AP Overrides
z Changing the Aruba AP Group for an AP Device
z Changing Adaptive Radio Management (ARM) Settings
z Changing SSID and Encryption Settings
Visibility in Aruba Configuration
z Visibility Overview
z Defining Visibility for Aruba Configuration
Using AWMS to Deploy Aruba APs for the First Time
For a complete reference on all Aruba Configuration pages, field descriptions, and certain additional procedures
that are more specialized, refer to Appendix A, “Aruba Configuration Reference” on page49.
To Next Page
Loading...
