AirWave Wireless Management Suite | Configuration Guide Aruba Configuration Reference | 153
Click Add to complete the configuration of the RADIUS server, or click Save to complete the editing of an
existing server. The new server appears on the
Security > Server Groups > RADIUS page. This server is now
available to be used by server groups.
Security > Server Groups > TACACS
You can configure TACACS servers for use by a server group. The Security > Server Groups > TACACS page
displays current TACACS servers available for inclusion in server groups. Click
Add to create a new
RADIUS server, or click the pencil icon next to an existing TACACS server to edit the configuration.
The
Security > Server Groups > Add New TACACS Server page contains the following fields, as described in
Table 65:
Acct Port 1813 Set the accounting port on the server.
Retransmits (0-3) 3 Set the Maximum number of retries sent to the server by the
controller before the server is marked as down.
Timeout (1-30 sec) Set the maximum time, in seconds, that the controller waits before
timing out the request and resending it.
NAS ID N/A Set the Network Access Server (NAS) identifier to use in RADIUS
packets.
NAS IP N/A Set the NAS IP address to send in RADIUS packets.
You can configure a “global” NAS IP address that the controller
uses for communications with all RADIUS servers. If you do not
configure a server-specific NAS IP, the global NAS IP is used.
Use MD5 No Enable or disable the use of MD5 hashing for cleartext passwords.
Enable Yes Enable or disable the RADIUS server.
Table 65 Security > Server Groups > TACACS
Field Default Description
General Settings
Folder Top Use this field to set and display the folder with which the server is
associated. The drop-down menu displays all folders available for
association with the server group.
Name Blank Enter the name of the server.
Other Settings
Host IP Address 0.0.0.0
Key (Confirm Key) N/A Set the shared secret to authenticate communication between
the TACACS+ client and server.
TCP Port 49 Set the TCP port to be used by the server.
Retransmits (0-3) 3 Set the maximum number of times a request is retried.
Table 64 Security > Server Groups > RADIUS (Continued)
Field Default Description
To Next Page
Loading...
