AirWave Wireless Management Suite | Configuration Guide Aruba Configuration Reference | 55
Click Add to complete the creation or click Save to complete the editing of the Aruba AP Group. This group
now appears in the navigation pane of the Aruba Configuration page.
802.11a Traffic
Management
Profile
default Specifies the minimum percentage of available bandwidth to be allocated to a specific SSID when
there is congestion on the wireless network, and sets the interval between bandwidth usage
reports. This setting pertains specifically to 802.11a.
IDS Profile default Selects the IDS profile to be associated with the new AP Group. The drop-down menu contains
these options:
z ids-disabled
z ids-high-setting
z ids -low-setting
z ids-medium-setting
The IDS profiles configure the AP’s Intrusion Detection System features, which detect and disable
rogue APs and other devices that can potentially disrupt network operations. An AP is considered
to be a rogue AP if it is both unauthorized and plugged into the wired side of the network. An AP is
considered to be an interfering AP if it is seen in the RF environment but is not connected to the
wired network.
Click the pencil icon next to this field to display the Profiles > IDS page of Aruba Configuration, and
adjust these settings as desired. Click Save on this page to return to the Add AP Group page.
Mesh Radio
Profile
default Determines many of the settings used by mesh nodes to establish mesh links and the path to the
mesh portal, including the maximum number of children a mesh node can accept, and transmit
rates for the 802.11a and 802.11g radios.
Mesh Cluster Profiles
Add New Mesh
Cluster Profile
N/A Click to display a new Mesh Cluster Profile section to this page, as illustrated in Figure 36.
Figure 34 Add New Mesh Cluster Profile Illustration
This section has two fields, as follows:
z Mesh Cluster Profile—Drop-down menu displays all supported profiles. Select one from the
menu.
z Priority (1-16)—Type in the priority number for this profile. The priority may be any integer
between 1 to 16.
Complete these fields, click the Add button, and the profile displays as an option in the Mesh
Cluster Profile section, which may be selected for the AP Group to be added or edited.
Table 4 Device Setup > Aruba Configuration > Aruba AP Groups Details, Settings and Default Values (Continued)
Field Default Description
To Next Page
Loading...
