AirWave Wireless Management Suite | Configuration Guide Aruba Configuration Reference | 85
Bootstrap
Threshold (1-65535)
8 Enter a threshold value from 0 to 65,535.
Adjust the bootstrap threshold to 30 if the network experiences packet
loss. This makes the AP recover more slowly in the event of a failure, but it
will be more tolerant to heartbeat packet loss.
Aruba recommends the default maximum request retries and bootstrap
threshold settings for most mesh networks; however, if you must keep
your mesh network alive, you can modify the settings as described in this
section. The modified settings are not applicable if mesh portals are
directly connected to the controller.
Request Retry
Interval
10 Enter in seconds the amount of time for retries. The supported range is
from 1 to 65,535 seconds.
Maximum Request
Retries
10 Maximum number of times to retry AP-generated requests. The default is
10 times. If you must modify this setting, Aruba recommends a value of
10,000. The range is from 1 to 65,535.
Keepalive Interval
(30-65535)
60 Define the keepalive interval in a range of 30 to 65,535 seconds.
Dump Server N/A Enter the IP address for the dump server.
Tel net No Enables Telnet in this system profile.
SNMP Sys-contact Enter an IP address to the value for SNMP sys_ contact, the SNMP system
Sys location.
RFprotect Server IP N/A Enter the IP address of the RFProtect server.
RFprotect Backup
Server IP
N/A Enter an IP address.
When an Aruba controller is present in an Aruba RFprotect system, an
Aruba AP that is acting as an RFprotect sensor can be configured and
managed from the controller. As a Managed Sensor, the Aruba AP is
managed by the controller but sends collected security data about the
wireless environment to an RFprotect Server.
Configure
Aeroscout RTLS
Server
No Enable this option if you wish to support an Aeroscout RTLS server.
Ortonics Walljack Yes Specify whether the Aruba controller uses an Ortonics walljack.
Ortronics® Wi-Jack™ and Wi-Jack Duo™ thin client access points are
centrally configured and managed by the Aruba Networks wireless
controllers to provide a high performance wireless network that integrates
seamlessly into the structured cabling infrastructure. When enabled, this
setting requires an Ortonics Access Point License.
Ortonics LED Off
Time-Out
Yes Enable the LED time-out function for Ortonics wall jacks when used. When
enabled, this setting requires an Ortonics Access Point License.
Ortonics Low Temp 100 Enter the low and high temperatures in Celsius for Ortonics wall jacks. The
range is from 0C to 255C degrees. When Ortonics is enabled, these
settings require an Ortonics Access Point License.
Ortonics High Temp 110
Configure RTLS
Server
No Enable this setting for Real-time Locating Systems (RTLS) server values
and the number of consecutive missed heartbeats on a GRE tunnel before
an AP reboots traps.
Table 20 Aruba Configuration > Profiles > AP > System Profile Settings (Continued)
Field Default Description
To Next Page
Loading...
