FrameMaker Ver5.5E(PC) Di152/Di183 GENERAL
01.08.27
G-6
3. PRECAUTIONS FOR USE
3-1. To ensure that the copier is used in an optimum condition
• Never place a heavy object on the copier or subject the copier to shocks.
• Insert the power plug all the way into the outlet.
• Do not attempt to remove any panel or cover which is secured while the copier is making
copies.
• Do not turn OFF the copier while it is making copies.
• Provide good ventilation when making a large number of copies continuously.
• Never use flammable sprays near the copier.
• If the copier becomes inordinately hot or produces abnormal noise, turn it OFF and
unplug it.
• Do not turn ON the power switch at the same time when you plug the power cord into the
outlet.
• When unplugging the power cord, do not pull on the cord; hold the plug and pull it out.
• Do not bring any magnetized object near the copier.
• Do not place a vase or vessel containing water on the copier.
• Be sure to turn OFF the power switch at the end of the workday or upon power failure.
• Use care not to drop paper clips, staples, or other small pieces of metal into the copier.
3-2. Operating Environment
The operating environmental requirements of the copier are as follows.
• Temperature: 10 to 30 °C
• Humidity: 15 to 85 % RH
• Rate of temperature change: 10 °C/h
• Rate of humidity change: 10 % RH/h
3-3. Power Requirements
The power source voltage requirements are as follows.
• Voltage fluctuation: AC110 to 127 V/220 to 240 V ± 10 %
(copying performance assured)
+10 %/-15 % (paper feeding performance assured)
• Frequency fluctuation: 50/60 Hz ± 0.3 %
3-4. Note
• It is prohibited to copy paper and hard currencies, government securities, and municipal
bonds (even when they are stamped as “Sample”).
• For fear of infringement of copyright, it is also prohibited to copy copyrighted works,
including books, music, works of art, maps, drawings, motion pictures, and photos
except when the copy is to be used only personally.
To Next Page
Loading...
