Develop D 1531iD - 13-6.Paper Take up Control; Paper Take up Retry Control

FrameMaker Ver5.5E(PC) Di152/Di183 MECHANICAL/ELECTRICAL
01.09.05
M-33
13-6. Paper Take Up Control
(1) Paper Take Up Retry Control
• To minimize the occurrence of a paper misfeed, the paper take-up sequence is tempo-
rarily halted if the paper fails to reach the Synchronizing Roller Sensor within a given
period of time after the sequence has been started. The paper take-up sequence is then
performed again. These paper take-up sequences are repeated a given number of times.
Elevtrical Component Control Signal
Forward
Rotation
OFF Wiring Diagram
M1
PWB-A PJ7A-5 L H
17-G
PWB-A PJ7A-7 H H
Elevtrical Component Control Signal ON OFF Wiring Diagram
SL1 PWB-A PJ5A-2 L H 1-I
Elevtrical Component Control Signal Activated Deactivated Wiring Diagram
PC1 PWB-A PJ6A-3 L H 1-F
No. of Paper Take-Up
Retry Sequences
Paper Take-Up Retry 2
ON
OFF
Start Key ON
Main Motor M1
ON
OFF
Paper Take-Up
Solenoid SL1
H
L
Synchronizing Roller
Sensor PC1
4021M515CA
ON
OFF
Paper Take-Up
Solenoid SL1
H
L
Synchronizing Roller
Sensor PC1
1st Paper Take-Up
Retry Sequence
Successful paper take-up
4021M514CA