FrameMaker Ver5.5E(PC) Di152/Di183 SWITCHES ON PWBs/TECH. REP. SETTINGS
01.07.26
S-5
2. User’s Choice Mode Setting Procedure
<Procedure>
1. Hold down the Panel Reset key for 3 seconds.
2. Enter “1” from the 10-Key Pad. (Display: U-1)
3. Press the Start key.
4. Enter the corresponding code number from the 10-Key Pad.
5. Press the Start key. Then, the Display will show the current setting value.
6. Press the Clear key to reset the current setting value.
7. Enter the new setting value from the 10-Key Pad.
8. Press the Start key. This will validate the new setting value just entered.
If any value outside the available setting range is entered, the Display shows “Err”
rejecting the entry. (The old setting value will reappear on the Display 1 sec. later.)
<Exiting the Mode>
• Press the Panel Reset key until the initial screen reappears.
3. Setting in the User’s Choice Mode
Code No.
Setting (The default is ).
C-1
<Mixed Orig.>
Select the priority Mixed Original Detection mode that is automatically
selected when the Power Switch is turned ON or Panel Reset key
pressed.
C-2
<Paper Priority>
Select the priority paper size or paper source that is automatically
selected when the copier is set into the Auto Size or Manual mode.
Initial setting: Metric area “6”/Inch area “15”
C-3
<Copy Priority>
Select the priority Auto mode (Auto Paper or Auto Size) selected
when the Power Switch is turned ON or Panel Reset key pressed.
Highlighted
Setting 0
Description Mixed Orig. enabled Mixed Orig. disabled
1
Setting Description Setting Description
0
1
2
3
4
5
7
8
10
11
A3 (L)
B4 (L)
A4 (L)
B5 (L)
A5 (L)
FLS (L)
A4 (C)
B5 (C)
A5 (C)
Ledger (L)
11×14 (L)
12
13
14
16
20
21
22
23
24
25
Legal (L)
Letter (L)
Invoice (L)
Letter (C)
Invoice (C)
1st Tray
2nd Tray
3rd Tray
4th Tray
5th Tray
Multiple Bypass Tray
6
15
Setting 1 2
Description Auto paper Auto Size Manual
0
To Next Page
Loading...
