Digi Connect IT 4

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
112
5. Create the routing policies. For example, to route all traffic from LAN1 through the public APN,
and LAN2 through the private APN:
a. Click Network > Routes > Policy-based routing.
b. Click the  to add a new route policy.
c. For Label, enter Route through public APN.
d. For Interface, select Interface: WWAN_Public.
e. Configure the source address:
i. Click to expand Source address.
ii. For Type, select Interface.
iii. For Interface, select LAN1.
f. Configure the destination address:
i. Click to expand Destination address.
ii. For Type, select Interface.
iii. For Interface, select Interface: WWAN_Public.
g. Click the  to add another route policy.
h. For Label, enter Route through private APN.
i. For Interface, select Interface: WWAN_Private.
j. Configure the source address:
i. Click to expand Source address.
ii. For Type, select Interface.
iii. For Interface, select LAN2.
k. Configure the destination address:
i. Click to expand Destination address.
ii. For Type, select Interface.