Digi Connect IT 4

Firmware configuration Using the command line
Digi Connect IT® 4 User Guide
39
The default username is admin. The default unique password for your device is printed on the
device label.
3. Depending on the device configuration, you may be presented with another menu, for example:
Access selection menu:
a: Admin CLI
1: Serial: port1 (9600,8,1,none,none)
q: Quit
Select access or quit [admin] :
Type a or admin to access the Connect IT 4 command line.
You will now be connected to the Admin CLI:
Connecting now...
Press Tab to autocomplete commands
Press '?' for a list of commands and details
Type 'help' for details on navigating the CLI
Type 'exit' to disconnect from the Admin CLI
>
See Command line interface for detailed instructions on using the command line interface.
Exit the command line interface
Command line
1. At the command prompt, type exit.
> exit
2. Depending on the device configuration, you may be presented with another menu, for example:
Access selection menu:
a: Admin CLI
1: Serial: port1 (9600,8,1,none,none)
q: Quit
Select access or quit [admin] :
Type q or quit to exit.