Digi Connect IT 4 User Manual

Interfaces Bridging
Digi Connect IT® 4 User Guide
198
Edit the preconfigured LAN bridge
Required configuration items
n Enable or disable the bridge.
n Modify the devices included in the bridge.
Additional configuration items
n Enable Spanning Tree Protocol (STP).
To edit the preconfigured LAN1 bridge:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Bridges > LAN1.
4. The LAN1 bridge is enabled by default. To disable, toggle off Enable.
5. Modify the list of devices that are a part of the bridge. By default, the LAN1 bridge includes the
following devices:
n Ethernet: LAN
n Wi-Fi access point: Digi AP (Wi-Fi1)
Note The MAC address of the bridge is taken from the first available device in the list.
a. To delete a device from the bridge, click the down arrow () next to the field label and
select Delete.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English