Digi Connect IT 4 User Manual

Firmware configuration Access the terminal screen from the web UI
Digi Connect IT® 4 User Guide
36
"result": {
"type": "array",
"path": "service.ssh.acl.zone"
, "collapsed": {
"0": "internal"
,
"1": "edge"
,
"2": "ipsec"
,
"3": "setup"
,
"4": "external"
}
}
}
$
2. Use the DELETE method to remove the external zone (list item 4).
$ curl -k -u admin https://192.168.210.1/cgi-
bin/config.cgi/value?path=service.ssh.acl.zone.4 -X DELETE
Enter host password for user 'admin':
{ "ok": true }
$
Access the terminal screen from the web UI
A user can log into a terminal screen and use CLI commands to access features.
Note You can also access the terminal screen from a port listed in the Serial Status page.
1. Log in to the web UI.
2. Click System > Terminal. The Terminal screen displays.
3. When prompted, enter your user name and password.
4. Enter the number of the port that you want to access.
5. Information about the port you are connected to displays, as well as commands.
Connecting to port5:
Settings: 9600, 8, 1, none, none
Type '~b.' to disconnect from port
Type '~b?' to list commands
6. Enter ~b? to display additional commands.
Note The ~bP, ~bO, and ~bN commands are used with the remote power management
feature. See Configure Remote Power Management.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English