Digi Connect IT 4 User Manual

Services Allow remote access for web administration and SSH
Digi Connect IT® 4 User Guide
467
Allow remote access for web administration and SSH
By default, only devices connected to the Connect IT 4's LAN have access to the device via web
administration and SSH. To enable these services for access from remote devices:
n The Connect IT 4 device must have a publicly reachable IP address.
n The External firewall zone must be added to the web administration or SSH service. See
Firewall configuration for information on zones.
n See Set the idle timeout for Connect IT 4 users for information about setting the inactivity
timeout for the web administration and SSH services.
To allow web administration or SSH for the External firewall zone:
Add the External firewall zone to the web administration service
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Web administration > Access Control List > Zones.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English