Digi Connect IT 4 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
146
3. Click Network > Interfaces.
4. Click the menu icon (...) next to the name of the WANor WWANto be deleted and select Delete.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the del command to delete the WANor WWAN. For example, to delete a WWANnamed my_
wwan:
(config)> del network interface my_wwan
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Default outbound WAN/WWAN ports
The following table lists the default outbound network communications for Connect IT 4 WAN/WWAN
interfaces:
Description TCP/UDP Port number
Digi Remote Manager
connection to
edp12.devicecloud.com
. TCP 3199
NTP date/time sync to
time.devicecloud.com
. UDP 123
DNS resolution using WAN-provided DNS servers. UDP 53
HTTPS for modem firmware downloads from
firmware.devicecloud.com
.
TCP 443

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English