Digi Connect IT 4 User Manual

Command line interface Configuration mode
Digi Connect IT® 4 User Guide
928
c. Enter enable ? to display help for the enable parameter:
(config service ssh)> enable ?
(config service ssh)>
Either of these methods will display the following information:
(config)> service ssh enable ?
Enable: Enable the service.
Format: true, false, yes, no, 1, 0
Default value: true
Current value: true
(config)> service ssh enable
Move within the configuration schema
You can perform configuration tasks at the CLI by moving within the configuration.
n Move forward one node in the configuration by entering the name of an Additional
Configuration option:
1. At the config prompt, type service to move to the service node:
(config)> service
(config service)>
2. Type ssh to move to the ssh node:
(config service)> ssh
(config service ssh)>
3. Type acl to move to the acl node:
(config service ssh)> acl
(config service ssh acl)>
4. Type zone to move to the zone node:
(config service ssh acl)> zone
(config service ssh acl zone)>
You can also enter multiple nodes at once to move multiple steps in the configuration:
(config)> service ssh acl zone
(config service ssh acl zone)>
n Move backward one node in the configuration by entering two periods (..):
(config service ssh acl zone)> ..
(config service ssh acl)>

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English