Digi Connect IT 4

Command line interface Command line reference
Digi Connect IT® 4 User Guide
947
Syntax
mv <source> <destination> [force]
Parameters
source: The source file or directory to move.
destination: The destination path to move the source file or directory to.
force: Do not ask to overwrite the destination file if it exists.
ping
Ping a host using ICMP echo.
Syntax
ping <host> [interface STRING] [source STRING] [ipv6] [size INTEGER] [count
INTEGER] [broadcast]
Parameters
host: The name or address of the remote host to send ICMP ping requests to. If broadcast is enabled,
can be the broadcast address.
interface: The network interface to send ping packets from when the host is reachable over a default
route. If not specified, the system's primary default route will be used.
source: The ping command will send a packet with the source address set to the IP address of this
interface, rather than the address of the interface the packet is sent from.
ipv6: If a hostname is defined as the value of the 'host' parameter, use the hosts IPV6 address.
size: The number of bytes sent in the ICMP ping request. (Minimum: 0, Default: 56)
count: The number of ICMP ping requests to send before terminating. (Minimum: 1, Default: 100)
broadcast: Enable broadcast ping functionality.
poweroff
Power off the system.
Syntax
poweroff
Parameters
None
reboot
Reboot the system.
Parameters
None
rm