System administration Reboot your Connect IT 4 device
Digi Connect IT® 4 User Guide
774
extension, but it is a tar file and can be unzipped with tar or a similar tool. See Use the scp command
for information about uploading files to the Connect IT 4 device.
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the modem firmware check command to determine if new modem firmware is available
on local device.
> modem firmware check
Checking for latest ATT firmware in flash ...
Newest firmware version available in flash is '05.05.58.00_ATT_005.026_000'
Modem firmware up to date
05.05.58.00_ATT_005.026_000
> modem firmware check
3. Use the modem firmware list command to list available firmware on the Connect IT 4 device.
> modem firmware list
ATT, 24.01.544_ATT, current
Generic, 24.01.514_Generic, image
Verizon, 24.01.524_Verizon, image
ATT, 24.01.544_ATT, image
Sprint, 24.01.531-B003_Sprint, image
>
4. To perform an firmware update by using a local file, use the version parameter to identify the
appropriate firmware version as determined using the modem firmware check or modem
firmware list command. For example::
> modem firmware update version 24.01.5x4_ATT
Updating modem firmware ...
-----------------------------
Successfully updated firmware
Modem firmware update complete
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Reboot your Connect IT 4 device
You can reboot the Connect IT 4 device immediately or schedule a reboot for a specific time every day.
To Next Page
Loading...
Need help?
General
