Digi Connect IT 4 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 4 User Guide
165
Show LAN status and statistics
Web
1. Log into the Connect IT 4 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network command at the Admin CLI prompt:
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
lan IPv4 up 192.168.2.1/24
lan IPv6 up fd00:2704::1/48
loopback IPv4 up 127.0.0.1/8
wan IPv4 up 10.10.10.10/24
wan IPv6 up fe00:2404::240:f4ff:fe80:120/64
modem IPv4 up 10.200.1.101/30
modem IPv6 down
>
3. Additional information can be displayed by using the show network verbose command:
> show network verbose
Interface Proto Status Type Zone Device Metric
Weight
---------------- ----- ------- ------ -------- -------- ------ ----
--
defaultip IPv4 up static setup lan 10 10
defaultlinklocal IPv4 up static setup lan 0 10
lan IPv4 up static internal lan 5 10
lan IPv6 up static internal lan 5 10
loopback IPv4 up static loopback loopback 0 10
wan IPv4 up dhcp external wan 1 10
wan IPv6 up dhcp external wan 1 10
modem IPv4 up modem external wwan1 3 10
modem IPv6 down modem external wwan1 3 10

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English