Digi Connect IT 4

Services Location information
Digi Connect IT® 4 User Guide
509
Location information
Your Connect IT 4 device can be configured to use the following location sources:
n User-defined static location.
n Location messages forwarded to the device from other location-enabled devices.
You can also configure your Connect IT 4 device to forward location messages, either from the
Connect IT 4 device or from external sources, to a remote host. Additionally, the device can be
configured to use a geofence, to allow you to determine actions that will be taken based on the
physical location of the device.
This section contains the following topics:
Configure the location service 510
Configure the device to use a user-defined static location 512
Configure the device to accept location messages from external sources 514
Forward location information to a remote host 518
Configure geofencing 525
Show location information 537