Digi Connect IT 4 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 4 User Guide
163
(config)> add network interface LAN_bridge_interface
(config network interface LAN_bridge_interface)>
c. Set the zone to internal:
(config network interface LAN_bridge_interface)> zone internal
(config network interface LAN_bridge_interface)>
d. Set the device to the new bridge:
(config network interface LAN_bridge_interface)> device
/network/bridge/LAN_bridge
(config network interface LAN_bridge_interface)>
e. Set the IPv4 address and netmask for the interface, using the format IPv4_
address/netmask, for example, 192.168.3.1/24:
(config network interface LAN_bridge_interface)> ipv4 address
192.168.3.1/24
(config network interface LAN_bridge_interface)>
f. Enable the DHCP server:
(config network interface LAN_bridge_interface)> ipv4 dhcp_server enable
true
(config network interface LAN_bridge_interface)>
5. Disable the wan interface:
(config)> network interface wan enable false
(config)>
6. Save the configuration and apply the change:
(config network interface LAN_bridge_interface)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the default LAN subnet
You can change the Connect IT 4 default LAN subnet—192.168.2.1/24—to any range of private IPs. The
local DHCP server range will also change to the range of the LAN subnet.
To change the LAN subnet:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English