Digi Connect IT 4

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
131
(config network interface my_wan)> ipv4 dhcp_hostname true
(config network interface my_wan)>
n See RFC4702 for further information about DHCP server support for the Client
FQDNoption.
n See Configure system information for information about setting the Connect IT
4 device's system name.
7. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface my_wan)> ipv6 enable true
(config network interface my_wan)>
b. Set the IPv6 type to DHCP:
(config network interface my_wan)> ipv6 type dhcpv6
(config network interface my_wan)>
c. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
(config network interface my_wan)> ipv6 ?
IPv6
Parameters Current Value
-----------------------------------------------------------------------
--------
dhcp_hostname false DHCP Hostname
enable true Enable
metric 0 Metric
mgmt 0 Management priority
mtu 1500 MTU
type dhcpv6 Type
use_dns always Use DNS
weight 10 Weight
Additional Configuration
-----------------------------------------------------------------------
--------
connection_monitor Active recovery
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.