Digi Connect IT 4

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
144
2. Enter the show network command at the Admin CLI prompt:
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
lan IPv4 up 192.168.2.1/24
lan IPv6 up fd00:2704::1/48
loopback IPv4 up 127.0.0.1/8
wan IPv4 up 10.10.10.10/24
wan IPv6 up fe00:2404::240:f4ff:fe80:120/64
modem IPv4 up 10.200.1.101/30
modem IPv6 down
>
3. Additional information can be displayed by using the show network verbose command:
> show network verbose
Interface Proto Status Type Zone Device Metric
Weight
---------------- ----- ------- ------ -------- -------- ------ ----
--
defaultip IPv4 up static setup lan 10 10
defaultlinklocal IPv4 up static setup lan 0 10
lan IPv4 up static internal lan 5 10
lan IPv6 up static internal lan 5 10
loopback IPv4 up static loopback loopback 0 10
wan IPv4 up dhcp external wan 1 10
wan IPv6 up dhcp external wan 1 10
modem IPv4 up modem external wwan1 3 10
modem IPv6 down modem external wwan1 3 10
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about WAN, enter show
network interface wan:
> show network interface wan
wan1 Interface Status
---------------------
Device : wan
Zone : external
IPv4 Status : up
IPv4 Type : dhcp