Digi Connect IT 4 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 4 User Guide
154
connection_monitor Active recovery
dhcpv6_server DHCPv6 server
(config network interface my_lan)>
View default settings for the IPv6 DHCP server:
(config network interface my_lan)> ipv6 dhcpv6_server ?
DHCPv6 server: The DHCPv6 server settings for this network interface.
Parameters Current Value
-----------------------------------------------------------------------
--------
enable true Enable
(config network interface my_lan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
minimum length of the prefix:
(config network interface my_lan)> ipv6 prefix_length 60
(config network interface my_lan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
8. (Optional) To configure 802.1x port based network access control:
Note The Connect IT 4 can function as an 802.1x authenticator; it does not function as an
802.1x supplicant.
a. Enable the 802.1x authenticator on the Connect IT 4 device:
(config network interface my_lan)> 802_1x authentication enable true
(config network interface my_lan)>
b. Set the frequency period for reauthorization:
(config network interface my_lan)> 802_1x authentication reauth_period
value
(config network interface my_lan)>
where value is an integer between 0 and 86400. The default is 3600.
9. (Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English