Digi Connect IT 4 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 4 User Guide
189
h. See Configure SureLink active recovery to detect WAN/WWAN failures for information
about configuring SureLink for active recovery.
17. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface or edit an existing one:
n To create a new interface named ip_passthrough_interface:
(config)> add network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
n To edit an existing interface named ip_passthrough_interface, change to the IP-
passthrough-interface node in the configuration schema:
(config)> network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
4. Set the interface type to passthrough:
(config network interface ip_passthrough_interface)> type passthrough
(config network interface ip_passthrough_interface)>
5. Set the firewall zone to internal:
(config network interface ip_passthrough_interface)> zone internal
(config network interface ip_passthrough_interface)>
6. Select an Ethernet device or a Wi-Fi access point for this interface:
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Current value:
(config network interface ip_passthrough_interface)> device
b. Set the device for the interface:
(config network interface ip_passthrough_interface)> device device
(config network interface my_wan)>
7. Set passthrough options

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English