Digi Connect IT 4

Serial port Configure Login mode
Digi Connect IT® 4 User Guide
211
4. Set the mode:
(config)> serial port1 mode login
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
6. Set the baud rate used by the device to which you want to connect:
(config)>serial port1 baudrate rate
(config)>
7. Set the number of data bits used by the device to which you want to connect:
(config)>serial port1 databits bits
(config)>
8. Set the type of parity used by the device to which you want to connect:
(config)>serial port1 parity parity
(config)>
Allowed values are:
n even
n odd
n none
The default is none.
9. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 stopbits bits
(config)>
10. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 flow value
(config)>
where value is one of:
n none
n rts/cts
n xon/xoff
11. Configure serial port logging:
a. Enable serial port logging:
(config)>serial port1 logging enable true
(config)>
b. Set the file name: