Digi Connect IT 4 User Manual

Serial port Configure UDP serial mode
Digi Connect IT® 4 User Guide
239
6. Expand Serial Settings.
a. For Baud rate, select the baud rate used by the device to which you want to connect.
b. For Data bits, select the number of data bits used by the device to which you want to
connect.
c. For Parity, select the type of parity used by the device to which you want to connect.
d. For Stop bits, select the number of stop bits used by the device to which you want to
connect.
e. For Flow control, select the type of flow control used by the device to which you want to
connect.
7. Expand Data Framing Settings.
a. Click to expand Data Framing.
i. Click Enable to enable the data framing feature.
ii. For Maximum Frame Count, enter the maximum size of the packet. The default is
1024.
iii. For Idle Time, enter the length of time the device should wait before sending the
packet.
iv. For End Pattern, enter the end pattern. The packet is sent when this pattern is
received from the serial port.
v. Click Strip End Pattern if you want to remove the end pattern from the packet
before it is sent.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English