Serial port Configure UDP serial mode
Digi Connect IT® 4 User Guide
241
n To limit access to specified IPv4 addresses and networks:
i. Click IPv4 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv4 address or network that can access the device's
service-type. Allowed values are:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the service-type.
iv. Click again to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
i. Click IPv6 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv6 address or network that can access the device's
service-type. Allowed values are:
To Next Page
Loading...
