Digi Connect IT 4

Routing IP routing
Digi Connect IT® 4 User Guide
260
New static route instances are enabled by default. To disable:
(config network route static 0)> enable false
(config network route static 0)>
4. (Optional) set a label that will be used to identify this route. For example:
(config network route static 0)> label "route to accounting network"
(config network route static 0)>
5. Set the IP address or network of the destination of this route. For example:
(config network route static 0)> destination ip_address[/netmask]
(config network route static 0)>
For example, to route traffic to the 192.168.47.0 network that uses a subnet mask of
255.255.255.0:
(config network route static 0)> dst 192.168.47.0/24
(config network route static 0)>
The any keyword can also be used to route packets to any destination with this static route.
6. Set the interface on the Connect IT 4 device that will be used with this static route:
a. Use the ? to determine available interfaces:
(config network route static 0)> interface ?
Interface: The network interface to use to reach the destination.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network route static 0)> interface
b. Set the interface. For example:
(config network route static 0)> interface /network/interface/wan
(config network route static 0)>
7. (Optional) Set the IPv4 address of the gateway used to reach the destination. Set to blank if
the destination can be accessed without a gateway.
(config network route static 0)> gateway IPv4_address
(config network route static 0)>
8. (Optional) Set the metric for the route. When multiple routes are available to reach the same
destination, the route with the lowest metric is used.