Digi Connect IT 4

Routing IP routing
Digi Connect IT® 4 User Guide
269
b. Set the interface. For example:
(config network route policy 0)> src interface
/network/interface/wan
(config network route policy 0)>
n address: Matches the source IPv4 address to the specified IP address or network. Set
the address that will be matched:
(config network route policy 0)> src address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
n address6: Matches the source IPv6 address to the specified IP address or network. Set
the address that will be matched:
(config network route policy 0)> src address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
n mac: Matches the source MAC address to the specified MAC address. Set the MAC
address to be matched:
(config network route policy 0)> src mac MAC_address
(config network route policy 0)>
10. Set the destination address type:
(config network route policy 0)> dst type value
(config network route policy 0)>
where value is one of:
n zone: Matches the destination IP address to the selected firewall zone. Set the zone:
a. Use the ? to determine available zones:
(config network route policy 0)> dst zone ?
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Default value: any